5 Steps for Flushing Your Water Heater

10/17/2019 (Permalink)

A leaking water heater can cause a lot of water damage in your Virginia Gardens, FL home

5 Steps for Flushing Your Water Heater

A leaking water heater can cause a lot of water damage that can result in costly water cleanup and restoration. To prevent problems with your heater, you need to flush out the sediment that builds up on the inside. While you could hire a plumber to perform the routine flush, you can also do it yourself by following these steps.

1. Gather Supplies

What makes this a fairly simple DIY job is that it only requires things you probably already own. You just need a screwdriver and a garden hose. It's also a good idea to identify a safe place to drain the water.

2. Take Safety Precautions

You want to make sure you perform the water heater flush safely. Turn off its power source, whether it is the breaker or the gas, before you begin. Be sure to wear thick work gloves so you don't get burned.

3. Drain the Heater

Put one end of the garden hose on the drain valve on the water heater and the other end of the hose in the area where you want the water to go. Open the valve and let the water flow. To speed up the draining process, turn on a hot water faucet in the house. Cut off the water supply valve, and then turn it on again once the water flow stops for an extra flush.

4. Refill the Tank

To fill the heater back up, close the valves and turn on the water supply. The hot water faucet you left on may sputter for a while as air in the line escapes. The tank is full when water flows out of the faucet normally.

5. Restore Power

After the tank is full, it is safe to turn the power back on. This allows the water in the tank to heat.
To prevent flooding to your home in Virginia Gardens,FL, you need to flush out your water heater regularly. This can save you a lot of money in the long run.